Students at Olin College have made a robot that can crack a MasterLock brand padlock’s combination; it can work faster depending on whether it knows some, none or all of the combination. The documentation for the project is quite good.
Our final design was able to dramatically reduce the amount of material needed by turning the entire assembly on its side. In this way, the motor mount and spindle, the lock holder and the solenoid could all be considered distinct entities attached to a single base plate. Since torque on the base was not an issue like it was with the first two “tower” designs, we could make the base much thinner. This allowed us to make our slots longer without increasing the total cost much. Thus, we were able to make every component adjustable relative to the fixed lock base which allowed for quick insertion and removal of the lock, as well as easy tuning of the solenoid distance that allowed it to consistently pull the lock latch all the way open. This was critical because one of the main problems we dealt with was assuring the location of the solenoid relative to the lock. The solenoid had a very thin range of positions that it would work from; too far from the lock it did have enough energy to pull the latch, too close to the lock and it didn’t have the travel to pull the latch completely open.
(via Neatorama)
- Safe-cracking robot autodials combinations to brute-force a high …
- Personal Account of Safe-Cracking "Penetration Party." – Boing Boing
- Locksmiths freak out over "Safecracking for the computer scientist …
- Homebrew "lockpick" slides under door and turns handle – Boing Boing
- Profile of the lock-hacker who bumped the "unbumpable" Medeco lock …
- Operation meets lock picking – Boing Boing
- Wearable lockpicks – Boing Boing