Livejournal’s Snuffykin followed the plans in Craft magazine to replace the uppers on her worn-out shoes with knitted versions. The newly remade Converse kick all kinds of ass.
The shoe part:* I cut the uppers and tongues off of Champion flat tops, then put several layers of gesso on the surfaces to whiten them up. I finished this with a few coats of matte sealer.
* Heavy duty yarn is hard to find. I found it at Joann Fabrics, finally.
* Since the Champion shoe material was leather and not fabric like Converse, a sewing needle didn’t go through easily. I used a bookbinding awl to punch holes through the layers of leather around the sole before sewing. Still, it was tricky.
* The Champion heel was shorter than the Converse heel, so I seamed the pieces rising above short heel.
* Running out of time, I sewed using running stitch, which actually holds up.The results:
The shoes are wearable, walkable, but floppy. Partly because the heel is too short. I could have just followed the instructions for a size 8 for a more snug fit. They’re messy looking, due to my rush to finish, but I’m not going to change a thing. I never wore those shoes anymore, but now they’re just for special occasions. :)
(via Craft)